What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
14.06.2025 05:07

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Barnstars:
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Did another parent ever tell you something about your child that you didn’t know?
What is lightning?
Now when you have a certain ac resistance, then a current flows in a loop.
For this case there are devices called Metal oxide varistors (MOV).
One
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
In schematic diagrams this is the symbol for a fuse:
Do you think the number of sissies is on the rise?
so, what happens?
[image of Common-mode choke]
but this device (an Inductor) … impedes the rapid changes in the current.
What was your biggest culture shock going to Europe?
The other is “what does a “fuse” do?”
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
But it can get overloaded, and no longer works.
What's the most valuable lesson you've learned in life, and how has it impacted your journey so far?
This device then solves the entire problem.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
A circuit breaker is similar, but is resettable.
Why would my husband cheat on me with an ugly fat woman?
Upvotes:
A fuse is a non-resetable over current circuit protector.
This is where the MOV conducts again, and dissipated the energy.
The bolt then partially travels down the line to your home.
[old diagram got deleted by accident]
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
If babies could write, what questions would they ask on Quora?
Because the load is inductive, the current lags the voltage.(by a bit).
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Edit 2024–10.
What was your best revenge story?
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
One is “what exactly is in a ‘surge protector’ ? ”
I post the exact comment here.
eight
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
But… the neutral is now “floating” because of the 1 ohm resistance.
He then describes Rainy Season and Lightning.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
but I think this circuit , shows a few more pieces.
nine
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
What does a fuse do?
An AC voltage/ current source, and an ac inductive load.
At least they know the answer if they wanted it.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
a photo is worth a thousand words.
These devices are installed between the “hot” and “neutral” and protective ground.
There are three different concepts here that are getting confused.
He then asserts :
First Sentence:
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
This one hit behind the barn.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This is 'the assistant's answer'
This is the picture of an electronic coil of wire wound around a core of magnetic material.
what exactly is a ‘surge’ protector?
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
The third is lightning and “how it gets conducted into a home.”
This is where this question deviates from being a 'generic' question, and becomes more specific.
There are two important concepts here.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
(Dc diagram shown, AC is similar).
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
2024–10–16 [ OO OLAOYE OYEBODE ]
He then describes the function of a fuse.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–10[John johnson John Johnson ]
The MOV will conduct when the voltage exceeds 50% of line voltage.
2024–10–14 [Omar Gharbi Omar Gharbi ]
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
It seems Mohan does not understand the difference between a comment and an Answer.
Here is a simplified AC power diagram.
the problem then depends on "how fast does the fuse operate?".
These are simplified answers to the original question, and does not change anything I wrote above.
So, the voltage could go up to 500 volts, and the fuse will not open up.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
It also is a device that limits the change in current flow.